Advanced Control Technologies Inc. 0791-01 Manuale Utente

ZRF113 Instructions, Release 5.1 

P/D 081110

0791-01

3

Power:   

120 VAC, 50/60 Hz

Signal (Frequency):  908.42 MHz 
Maximum Load 
 

Isolated Contacts:  20 amps G.P. maximum, 277 VAC, 10FLA, 60LRA, 250VAC, 

 

Motor:    

  1 H.P. maximum, 120/240 VAC

 

Incandescent:      TV8 (Tungsten), 120 VAC, 960W maximum 

Range:  Up to 100 feet line of sight between the Wireless Controller and /or the closest HomePro Receiver  

 

  Module

A  Z-Wave™ network can integrate devices of various classes, and these devices can be made by different 

manufacturers.  The ZRF113 can be incorporated into existing Z-Wave™ networks.
The button on the face of the ZRF113 can be used to carry out inclusion, association, or exclusion.

The ZRF113 is certified to comply with applicable FCC and IC rules 

and regulations governing RF and EMI emissions.  

This device complies with part 15 of the FCC Rules. Operation is 

subject to the following two conditions: (1) This device may not cause 

harmful interference, and (2) This device must accept any interference 

received, including interference that may cause undesired operation.
FCC NOTICE
Note:  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 

of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in ac-

cordance with the instructions may cause harmful interference to radio communications.  However, there is no guarantee 

that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct 

the interference by one or more of the following measures:
   

-  Reorient or relocate the receiving antenna.

-  Increase the separation between the equipment and receiver.

  

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority 

to operate the equipment.
IC NOTICE
This Class B digital apparatus complies with Canadian 

ICES-003

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device 

must accept any interference, including interference that may cause undesired operation of the device.