Honeywell International Inc. CS19A Manuale Utente
4 - 13
Illumination Lights
If you want the illumination lights on while reading a bar code, scan the Lights
On
On
bar code, below. However, if you want to turn just the lights off, scan the
Lights Off
bar code.
Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set
using
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before
the picture is taken. Use these codes to set the time between when the trigger
is pulled and when the picture is taken. During the delay time, the aiming light
will appear, but the LEDs won’t turn on until the delay time is over.
the picture is taken. Use these codes to set the time between when the trigger
is pulled and when the picture is taken. During the delay time, the aiming light
will appear, but the LEDs won’t turn on until the delay time is over.
Default =
Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar
code below, then set the time-out by scanning digits (0 - 4,000 ms) from the
code below, then set the time-out by scanning digits (0 - 4,000 ms) from the
inside the back cover of this manual, then scan Save.
Lights Off
* Lights On
400 milliseconds
* Off
(no delay)
200 milliseconds
Delay Duration
Preliminary Draft