Honeywell International Inc. CS19A Manuale Utente

4 - 11

When this mode is selected, your scanner is optimized to read bar codes from 
mobile phone or other LED displays.  However, the speed of scanning printed 

bar codes may be slightly lower when this mode is enabled.  You can enable 
Mobile Phone Reading for either a hand held device, or for a hands-free (pre-
sentation) application.  

Note: To turn off Mobil Phone Read Mode, scan a Manual or Serial Trigger 

 tells the scanner to take a picture (rather than read a bar 

code) when the trigger is pressed.  Once the picture is snapped, it is shipped to 
the host system as a jpeg file by default.  To revert to bar code reading, you 
must change to a different trigger mode (see 

Note: You must use an RS232 interface to use this code.  Otherwise, menu 

codes will not work until you send a serial command for 

The Scan Stand and Presentation Modes are referred to as “hands free” 
modes.  If the scanner’s trigger is pulled when using a hands free mode, the 
scanner changes to manual trigger mode.  You can set the time the scanner 
should remain in manual trigger mode by setting the Hands Free Time-Out.  
Once the time-out value is reached, (if there have been no further trigger pulls) 
the scanner reverts to the original hands free mode.  

Preliminary Draft