Honeywell International Inc. CS19A Manuale Utente

Pagina di 294
13 - 2
• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the 
original interface cable.
Replacing an Interface Cable
1. Turn the power to the host system 
OFF.
2. Disconnect the scanner’s cable 
from the terminal or computer.
3. Locate the small hole on the back 
of the scanner’s handle.  This is 
the cable release.
4. Straighten one end of a paper 
clip.
5. Insert the end of the paper clip 
into the small hole and press in.  
This depresses the retention tab, 
releasing the connector.  Pull the 
connector out while maintaining 
pressure on the paper clip, then 
remove the paper clip.
6. Replace with the new cable.  
Insert the connector into the opening and press firmly.  The connector is 
keyed to go in only one way, and will click into place.
Replacing Cables and Batteries in Cordless 
Systems
Replacing an Interface Cable in a Base
1. Turn the power to the host system 
OFF.
2. Disconnect the base’s cable from the 
terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while 
maintaining pressure on the 
connector release clip.
5. Replace with the new cable.  
Insert the connector into the opening 
Cable
Release
Preliminary Draft