Honeywell International Inc. CS19A Manuale Utente

13 - 3

and press firmly.  The connector is keyed to go in only one way, and will 
click into place.

1. Loosen the thumbwheel 

screw on the end cap by 
hand or use a hex wrench.

2. Remove the battery from 

the handle.

3. Insert replacement 

battery.

4. Replace end cap and 

screw.

The scanner automatically performs self-tests whenever you turn it on.  If 
your scanner is not functioning properly, review the following Troubleshoot-
ing Guide to try to isolate the problem.

If the aiming beam isn’t illuminated, check that:

• The cable is connected properly.
• The host system power is on (if external power isn’t used).
• The trigger works.

If the scanner isn’t reading symbols well, check that the symbols:

• Aren’t smeared, rough, scratched, or exhibiting voids.
• Aren’t coated with frost or water droplets on the surface.
• Are enabled in the scanner or in the decoder to which the scanner 

connects.

The bar code is displayed on the host device correctly, but you still have to 
press a key to enter it (the Enter/Return key or the Tab key, for example).

• You need to program a suffix.  Programming a suffix enables the scanner 

to output the bar code data plus the key you need (such as “CR”) to enter 
the data into your application.  Refer to 

Preliminary Draft