Honeywell International Inc. CS19A Manuale Utente
3 - 8
Paging
Paging Mode
By default, the paging button on the base pages the scanners associated
with that base. If you want the paging button on your base to be disabled,
scan the Paging Mode Off bar code, below. When Paging Mode is off, the
scan the Paging Mode Off bar code, below. When Paging Mode is off, the
base will no longer page scanners when the button is pressed. The red
LED on the base will remain lit to indicate that Paging Mode is off. (This
light will go out when the button is pressed, then back on when it’s
LED on the base will remain lit to indicate that Paging Mode is off. (This
light will go out when the button is pressed, then back on when it’s
released.)
Default = Paging Mode On.
Paging
Pitch
When you press the Page button on the base, the scanners associated
with that base will begin beeping (see
with that base will begin beeping (see
on page 3-3). You can
set the pitch of the paging beep for each scanner by scanning one of the
following bar codes.
following bar codes.
Default = Low.
* Paging Mode On
Paging Mode Off
* Low (1000 Hz)
Medium (3250 Hz)
High (4200 Hz)
Preliminary Draft