Honeywell International Inc. CS19A Manuale Utente

3 - 12

If you need to replace a broken or lost scanner that is linked to a base, 
scan the Override Locked Scanner bar code below with a new scanner 
and place that scanner in the base.  The locked link will be overridden; the 
broken or lost scanner’s link with the base will be removed, and the new 
scanner will be linked.

If your scanner is out range of the base, an alarm sounds from both your base 
and scanner.  The alarm stops when the scanner is moved closer to the base, 
when the base connects to another scanner, or when the alarm duration 
expires.  To activate the alarm options for the scanner or the base and to set the 
alarm duration, scan the appropriate bar code below and then set the time-out 
duration (from 0-3000 seconds) by scanning digits on the 

inside the back cover, then scanning Save.  

Default = 0 sec (no alarm).

Note: If you are out of range when you scan a bar code, you will receive an error 

tone even if you do not have the alarm set.  You receive the error tone 

since the data could not be communicated to the base or the host.

If you have set the out-of-range alarm enabled, you may change the alarm 
type for the scanner or base by scanning the appropriate bar code below 
and then scanning a digit (0-7) bar code and the Save bar code on the 

 inside the back cover of this manual.  

Default = 0.  

The sounds are as follows:

0

3 long beeps, medium pitch

1

3 long beeps, high pitch

Preliminary Draft