Honeywell International Inc. CS19A Manuale Utente

3 - 28

Scan the Relink Time-Out bar code, then scan the number of seconds for 
the setting (from 1-100) from the inside back cover.  Scan Save to save the 
setting.  

Default = 3 seconds.

When the scanner goes out of range, the scanner repeatedly attempts to 
connect to base unit.  Each attempt consists of approximately 5 seconds of 

active time followed by 3 seconds of idle time.  After one hour, the scanner 
powers off and batch mode data is lost.

When the scanner goes out of range, 15 attempts are made to link to the 
base unit.  Each attempt consists of approximately 5 seconds of active time 
followed by 3 seconds of idle time.  After 15 cycles (8*15 =120), or about 2 

minutes, the scanner stops trying to connect to the base unit, but retains 
any bar codes that may have been saved in batch mode.  After one hour, 
the scanner powers off and batch mode data is lost.

When the scanner goes out of range, no action is taken to re-link.  When  
the trigger is pulled, 15 attempts are made to link to the base unit.  Each 
attempt consists of approximately 5 seconds of active time followed by 3 
seconds of idle time.  After 15 cycles (8*15 =120), or about 2 minutes, the 
scanner stops trying to connect to the base unit, but retains any bar codes 
that may have been saved in batch mode.  After one hour, the scanner 
powers off and batch mode data is lost. Refer to 

, page 3-26, to review other events that can start the re-link process.

Auto Reconnect Mode set to 1
Maximum Link Attempts set to 0 
Relink Time-Out set to 10
Scanner Power Time-Out Timer set to 1800
Note: See 

The scanner attempts to connect to the base unit every 15 seconds, mea-
sured from start of attempt to start of attempt.  After one half hour, the 
scanner powers off.

Preliminary Draft