Honeywell International Inc. CS19A Manuale Utente

3 - 26

Auto Reconnect controls whether or not the scanner automatically begins 
the re-link process when a loss of connection is detected.  When the Auto 
Reconnect On

 bar code is scanned, the scanner begins the re-link pro-

cess immediately, without user intervention.  

Default = Auto Reconnect On.

Note: If you are connecting to a Bluetooth Interface Module, set Auto 

Reconnect to Off.

The table below shows the results of the Auto Reconnect On and Off set-
tings: 

Scanner out of 
range

Re-link occurs 
automatically.  If 
maximum number of link 
attempts (see 

3-27) is unsuccessful, 
then the trigger must be 
pulled or the scanner 
must be placed in the 
base unit to re-link.

The trigger must be 
pulled to initiate re-
linking.

Base reset 
(firmware upgrade 
or power cycle)

Scanner behaves as if 
out of range.

No attempt to re-link 
made while base unit 
is powered off.  
Trigger must be 
pulled to initiate re-
linking.

Scanner power 
down due to Power 
Time-Out Timer 
setting (see 

Trigger must be pulled or the scanner must be 
placed in the base unit to re-link.
(Note: scanner re-links on power up, but powers 
on due to one of the above actions.)

Preliminary Draft