Everspring Industry Co Ltd ST814 Manuale Utente
3
2
3
4
1
5
Installation
Please follow the steps below in sequence to load the batteries.
1. Undo and remove the screw from the bottom edge
of the detector to detach the rear cover.
2. Open the mounting bracket.
3. Unscrew the screw from the battery cover.
4. Remove the battery cover.
5. Insert 3 AA-size 1.5V alkaline batteries to the
battery compartment, ensuring correct polarity is
put.
put.
6. Replace the battery cover and then engage the
detector to the rear cover firmly.
Note: After removing batteries, please wait for 5 seconds before replacing them.
Operation
There are 8 modes available for selection. Press
to select desired mode
for different settings.
Mode Function
1
1
Current temperature display (°C/°F)
2
Current humidity display (%)
3
Setting for temperature trigger-ON value
4
Setting for temperature trigger-OFF value
5
Setting for humidity trigger-ON value
6
Setting for humidity trigger-OFF value
7
Setting for turning on/off Radio Frequency
8
Setting for turning on/off beep tone
MODE 1 & MODE 2 are showing as main displays on the screen. Once mode
setting is finished (MODE 3 to MODE 8), the screen will return to main display
automatically after 12 seconds, or by pressing
to return to main display.
1. Temperature
1.1 Display of Current Temperature
Press
and select MODE 1 to display current temperature, and toggle
to select the unit of temperature (。C /。F).
The temperature ranges from -20。
C to 50。
C . To show the last record of max/min
temperature, press
or
. To clear the record, press both
and
at the same time.
Threshold Limit Warning:
If the temperature is reaching the limit, the icon of MAX or MIN will be displayed
on the screen.
Ice Warning:
If the temperature falls to 0。
C , temperature display will illuminate with LCD back
light and beep tone will sound continuously for 1 second. Press any key to stop
the beep tone.
1.2 Temperature Trigger-ON
Press
the beep tone.
1.2 Temperature Trigger-ON
Press
and select MODE 3 to enter setting of temperature trigger-ON.
Icon
flashes and the screen shows the recorded trigger-ON temperature. If
no value is preset, the screen will display “
- - -。C ”.
Mode 1
Mode 2
Mode 3
Mode 4
Mode 5
Mode 6
Mode 7
Mode 8