Honeywell International Inc. 8DL5800PIR-OD Manuale Utente

– 

2

 – 

 

 

1. 

Install the Back Box on the 
wall with the two T4 x 20 
mounting screws. 

UP

 

2. 

Insert the batteries (see 
Install/Replace the Battery), 
then secure the Detector to the 
Back Box. 

3. 

Fasten with four (4) screws. 

 

4. 

Perform Settings & Adjustments. 

5. 

Perform a Walk Test. 

6. 

Secure the Cover with the Captive Lock Screw. 

 

 

 

1. 

Use a pole with an outside 
diameter of 43-48mm  
(1.69-1.89"). 

 

 

2. 

Attach the Brackets to the Back 
Box with two M4 x 30 screws. 

 

 

 

3. 

Using the Pole Brackets and four 
M4 x 30 screws, fasten the Back 
Box to the pole. 

 

UP

 

4. 

Insert the batteries (see 
Install/Replace the 
Battery), then mount the 
Detector on the Back Box 
and fasten with four (4) 
screws. 

5. 

Perform Settings & 
Adjustments. 

6. 

Perform a Walk Test. 

7. 

Secure the Cover with the 
Captive Lock Screw. 

Note: The length of the lower detection area determines the detection length. 
The upper detection area stays parallel to the ground at all times.  The lower detection area can be adjusted as shown below by the switch 
position. 
Detection length is therefore limited by the length of the lower detection area since both upper and lower areas have to be blocked at the 
same time to activate the sensor. 
IMPORTANT:  
ƒ

 

This sensor detects temperature differences between the moving object and the background temperature in the detection area to produce a 
valid detection.   

ƒ

 

If the object does not move, the sensor will not detect it. 

ƒ

 

If there is traffic near the detection area, adjust the detection area length 1.5 to 2.0m (5 to 7ft) back from traffic.