Conifer Corporation 2278 Manuale Utente
Antenna
Output
GPS Antenna
GP-0100
Transverter
TR-2278
Response Antenna
QD-2450
Antenna Port
(located on side of transverter)
GPS
Port
Polarity
Position
INSTALLATION / ASSEMBLY
with QD-2450 Response Antenna
1. Determine the polarity of the antenna. (See Figure 1.)
NOTE: See labeling on the back of the QD-2450 antenna for horizontal
and vertical polarity positioning.
and vertical polarity positioning.
2. Connect the QD-2450 antenna output to the antenna port on the side of
the Transverter. (See Figure 1.)
the Transverter. (See Figure 1.)
3. Secure the transverter and antenna connection with a #6 stainless
screw on each side of the Transverter. (See Figure 1.)
screw on each side of the Transverter. (See Figure 1.)
4. Connect the GPS Antenna to the GPS port on the Transverter. (See
Figure 1.)
Figure 1.)
NOTE: Warning! GPS Port Only - +5VDC output 0 VDC input maximum.
Figure 1
#6 Stainless Screw
(One on each side)
(One on each side)
V
E
R
HOR
Page 3.
Figure 5
Mast Clamp
U-Bolt
Figure 6
Mast Clamp
Tilt Holes
Mast Clamp
6. Attach the feed on the
front with 2 carriage
bolts. Secure on the
back with the lockwashers
and nuts. (See Figure 4.).
bolts. Secure on the
back with the lockwashers
and nuts. (See Figure 4.).
7. Place the 2 mast clamps on
the 2 U-bolts. (See Figure
6). Fasten the U-bolts on
the “L” bracket with the 4
lockwashers and nuts
(See Figure 5).
6). Fasten the U-bolts on
the “L” bracket with the 4
lockwashers and nuts
(See Figure 5).
NOTE:
By eliminating 1 mast
clamp and U-bolt, the optional
fixed tilt holes provide eleva-
tion in 10
fixed tilt holes provide eleva-
tion in 10
0
increments. (Not
recommended under high
wind conditions.) (See Figure
6.)
wind conditions.) (See Figure
6.)
Use the flat plate washer on
the adjustable tilt slot to
secure the antenna to the
required elevation. (See
Figure 7.)
the adjustable tilt slot to
secure the antenna to the
required elevation. (See
Figure 7.)
Figure 7
Tilt Slot
Page 10.
8. Connect the GPS Antenna to
the GPS port on the
Transverter. (See Figure 8)
Transverter. (See Figure 8)
9. Connect the 26T-2127
antenna output to the
antenna port on the side of
the Transverter. (See Figure
8)
antenna port on the side of
the Transverter. (See Figure
8)