Conifer Corporation 2278 Manuale Utente

1.  Place the sub-reflector on the

front of the feed and secure
with the #6 x 1/2" stainless
screw.   (See Figure 1).

2.  Determine the polarity of the

antenna.   (See figures 2 & 3).

Page 5.

1. Assemble the two halves

inserting the 4 #8-32
machine screws through
the front.  Secure with
the keps nuts on the back.
(See Figure 3).

Note: Loosely tighten
all hardware until
completely assembled
and then tighten
securely.

Horizontal  Polarity:

Refer to (figure 1) for proper feed
alignment.

Refer to (figure 2) for proper feed
alignment.

3. Determine the polarity of

the antenna.
(See Figures 1 & 2).

2. Place the sub-reflector on

the front of the feed and
secure with the #6 x 1/2”
stainless screw.   (See
Figure 4).

Page 8.