Honeywell International Inc. RTA-50D Manuale Utente
MAINTENANCE MANUAL
965-1696
(3)
Post-Installation Check
(a)
Required Test Equipment
1
Not applicable.
(b)
System Test
1
A functional self-test of the LRU can be initiated by pressing the test key push-button
on the front panel. Refer to Figure 1001.
on the front panel. Refer to Figure 1001.
2
The result of the functional self-test is displayed on the LEDs located on the front
panel.
panel.
3
After completion of functional self-test, the RTA-50D VDR status LED must be
green and all other LEDs must be off. For more information, refer to the FAULT
ISOLATION (PGBLK 23-20-59-1000) section.
green and all other LEDs must be off. For more information, refer to the FAULT
ISOLATION (PGBLK 23-20-59-1000) section.
C.
Flight Tests (Subtask 23-20-59-000-011-A01)
(1)
Preflight Test
(a)
The following test procedure gives instructions for a preflight test which ensures that the
RTA-50D VDR is functioning in an acceptable manner before takeoff.
RTA-50D VDR is functioning in an acceptable manner before takeoff.
(b)
Test Procedure
1
Establish the initial control settings. Refer to Table 2003.
Table 2003. Initial Control Settings
Control Panel
Position
Power
On.
Frequency selector
Tune to any local VHF frequency (local control tower or ground control
frequency).
frequency).
Volume control
Midrange.
2
Use the system headphones (or speaker) and microphone to check operation
of the RTA-50D VDR.
of the RTA-50D VDR.
3
Key the microphone and speak into it. Request a radio check and release the
PTT button.
PTT button.
4
As soon as possible, a local flight check must be made to verify system operation
for both local and distant stations.
for both local and distant stations.
(2)
In-Flight Confidence Test
(a)
After completion of the post-installation and preflight checks, a local flight can be made to
verify system operation for both local and distant stations. Repeat the test procedure
found in Paragraph 7.C. (Subtask 23-20-59-000-011-A01)(1)(b).
verify system operation for both local and distant stations. Repeat the test procedure
found in Paragraph 7.C. (Subtask 23-20-59-000-011-A01)(1)(b).
8.
Removal and Replacement (TASK 23-20-59-000-807-A01)
A.
Removal (Subtask 23-20-59-000-012-A01)
(1)
Loosen the two knurled screw clamps (located on the front of the mount) that attach the
RTA-50D VDR to the mount.
RTA-50D VDR to the mount.
(2)
Gently pull the RTA-50D VDR forward until it is disconnected from the rear connector and
the guide pins.
the guide pins.
EFFECTIVITY
ALL
23-20-59
Page 2010
1 Mar 2011
© Honeywell International Inc. Do not copy without express permission of Honeywell.