Harris Corporation RF Communications Division XG-100LPA Manuale Utente
14221-1200-4010, Rev. B
68
13. OPTIONAL CABLES
13.1 SERIAL PROGRAMMING CABLE CA-013671-020
Serial Programming Cable CA-013671-020 (20 feet long) can be used to program and configure the MRU
using a Personal Computer (PC). This cable can also be used to extend the length of GPS
NMEA-formatted serial data connections. The cable’s assembly and wiring diagrams are shown in Figure
13-1 below.
To program and configure the MRU, the cable’s male DB-9 connector (J1) is mated to the female DB-9
serial port connector on the rear of the MRU. Alternately, if the cable is being used to carry GPS
NMEA-formatted serial data from the MRU, its male DB-9 connector mates to connector P5 of Interface
Cable 14002-0174-03.
The cable’s female DB-9 connector (J2) mates to a PC’s male DB-9 serial port connector. If the PC is not
equipped with a DB-9 serial port connector, use a suitable adapter, such as USB-to-RS-232 Adapter
Cable CN24741-0001. The CN24741-0001 can be ordered through the Customer Care center; refer to
Section 4.3 on page 21 for contact information.
(Made From PS-CA-013671 Rev. -)
Figure 13-1: Serial Data Cable CA-013671-020