Manuali utente per Harris Corporation RF Communications Division XG-100LPA

Sommario

• 1. REGULATORY AND SAFETY INFORMATION

  8
  • 1.1 SAFETY SYMBOL CONVENTIONS

    8
  • 1.2 RF ENERGY EXPOSURE AWARENESS AND CONTROL INFORMATION FOR FCC OCCUPATIONAL USE REQUIREMENTS

    8
    • 1.2.1 Federal Communications Commission Regulations

      9
  • 1.3 COMPLIANCE WITH RF EXPOSURE STANDARDS

    9
    • 1.3.1 Mobile Antennas

      10
    • 1.3.2 Approved Accessories

      10
    • 1.3.3 Contact Information

      11
  • 1.4 RADIO FREQUENCY INTERFERENCE

    11
    • 1.4.1 FCC Part 15

      11
    • 1.4.2 Industry Canada

      11
  • 1.5 OCCUPATIONAL SAFETY GUIDELINES AND SAFETY TRAINING INFORMATION

    11
  • 1.6 COMMON HAZARDS

    12
  • 1.7 SAFE DRIVING RECOMMENDATIONS

    13
  • 1.8 OPERATING RULES REGULATIONS

    13
  • 1.9 OPERATING TIPS

    14
• 2. SPECIFICATIONS

  15
  • 2.1 GENERAL

    15
  • 2.2 TRANSMITTER

    16
  • 2.3 REGULATORY

    16
• 3. INTRODUCTION

  17
  • 3.1 GENERAL INFORMATION

    17
  • 3.2 EQUIPMENT MOUNTING

    17
  • 3.3 CONTROL HEADS

    17
    • 3.3.1 General Information

      17
    • 3.3.2 CH-100 Control Head

      18
    • 3.3.3 CH-721 Control Head

      18
  • 3.4 OPERATING POWER

    19
  • 3.5 RADIO PROGRAMMING

    19
  • 3.6 RELATED PUBLICATIONS

    21
• 4. Customer Service

  22
  • 4.1 TECHNICAL SUPPORT

    22
  • 4.2 TECH-LINK

    22
  • 4.3 CUSTOMER CARE

    22
• 5. UNPACKING AND CHECKING THE EQUIPMENT

  23
  • 5.1 MATERIALS

    23
• 6. PLANNING THE INSTALLATION

  30
  • 6.1 GENERAL INFORMATION

    30
  • 6.2 TOOLS REQUIRED

    30
  • 6.3 LOCATING COMPONENTS

    31
• 7. MOUNTING THE RADIO EQUIPMENT

  34
  • 7.1 INSTALL THE MOUNTING BRACKETS

    34
  • 7.2 MOUNT THE EQUIPMENT INTO THE BRACKETS

    38
    • 7.2.1 MRU and LBPA Mounting

      38
• 8. ANTENNA INSTALLATION

  41
  • 8.1 ANTENNA MOUNTING LOCATIONS

    41
    • 8.1.1 Direct Center or Center-Rear of Rooftop for MRU Antenna

      41
    • 8.1.2 Center of Trunk Lid for LBPA Antenna

      41
    • 8.1.3 Rear Deck Lid for GPS Stand-Alone GPS Receive Antenna

      43
  • 8.2 ANTENNA INSTALLATION PROCEDURES

    44
    • 8.2.1 Installing NMO Antenna Mounts AN-125001-001, -002, -003 and -004

      44
      • 8.2.1.1 Standard NMO Antenna Mounts AN-125001-001 and AN-125001-002

        44
      • 8.2.1.2 Thick-Roof NMO Antenna Mounts AN-125001-003 and AN-125001-004

        44
      • 8.2.1.3 Installation Procedure for Mounts AN-125001-001 through -004

        44
    • 8.2.2 Installing NMO Magnetic Antenna Mounts AN-125001-007 and -008

      47
    • 8.2.3 Installing all Other Antenna Mounts

      47
    • 8.2.4 Attaching NMO Antenna Elements

      47
    • 8.2.5 Connecting the Mobile Antennas

      49
    • 8.2.6 Connect RF Cable between Unity Mobile MRU and Low Band PA

      50
• 9. DC POWER INSTALLATION

  51
  • 9.1 OVERVIEW OF ON/OFF POWER WIRING CONFIGURATIONS

    51
  • 9.2 POWER INSTALLATION PROCEDURE

    52
    • 9.2.1 Radios DC Power Cables and Main Fuse Holders Installation

      52
      • 9.2.1.1 Black Wire Connections (Ground Wires)

        52
      • 9.2.1.2 Red Wires, Main Fuse Holder Connections (Radios’ Main Power Wires) and CAN Cable

        53
• 10. CONTROL HEAD INSTALLATION

  56
  • 10.1 SELECTING THE MOUNTING LOCATION

    56
  • 10.2 GENERAL INFORMATION ON THE CH-100 CONTROL HEAD

    57
  • 10.3 GENERAL INFORMATION ON THE CH-721 CONTROL HEAD

    59
  • 10.4 CONTROL HEAD MECHANICAL INSTALLATION

    61
  • 10.5 CONTROL HEAD-TO-RADIO CAN CABLE CONNECTIONS

    62
    • 10.5.1 General Information

      62
    • 10.5.2 Make CAN Link Terminations and Cable Connection

      64
  • 10.6 CONTROL HEAD POWER CABLE INSTALLATION

    64
    • 10.6.1 Install DC Power Cable and Make Power and Ground Connections

      65
    • 10.6.2 Connect DC Power Cable’s White Wire

      66
      • 10.6.2.1 Control Head and Radio Turn on with Vehicle’s Ignition Switch/Key

        66
      • 10.6.2.2 Control Head and Radio Turn On with a Manual Switch

        67
      • 10.6.2.3 Control Head and Radio Are “Hot Wired”

        67
• 11. SPEAKER INSTALLATION

  68
• 12. MICROPHONE ATTACHMENT

  68
• 13. OPTIONAL CABLES

  69
  • 13.1 SERIAL PROGRAMMING CABLE CA-013671-020

    69
  • 13.2 CH-100/CH-721 OPTION CABLE CA-011854-001

    70
  • 13.3 CH-721 SERIAL PROGRAMMING CABLE CA-104861

    71
  • 13.4 CH-721 MIC CONNECTOR PROGRAMMING CABLE CA-103541-001

    71
  • 13.5 OPTION CABLE 14002-0174-01

    72
• 14. GPS NMEA-FORMATTED SERIAL DATA CONNECTION

  76
• 15. MOBILE DATA CONNECTION

  76
• 16. INITIAL POWER-UP TEST

  77
• 17. PERFORMANCE TESTS

  79
  • 17.1 REQUIRED TEST EQUIPMENT

    80
  • 17.2 MRU TRANSMITTING INTO A 50-OHM LOAD/TERMINATOR

    81
  • 17.3 MRU TRANSMITTING INTO ITS ANTENNA

    83
  • 17.4 LOW BAND PA TRANSMITTING INTO A 50-OHM LOAD/TERMINATOR

    86
    • 17.4.1 For a 100 Watt Output Configuration

      86
  • 17.5 Low Band PA TRANSMITTING INTO ITS ANTENNA

    88
  • 17.6 TEST PERFORMANCE DATA FORM

    91
• 18. COMPLETE THE INSTALLATION

  93
• 19. WARRANTY REGISTRATION

  93
• 20. CLEANING THE RADIO EQUIPMENT

  94
  • 20.1 LIGHT-DUTY CLEANING PROCEDURE

    94
  • 20.2 HEAVY-DUTY CLEANING PROCEDURE

    94
• 21. WIRING DIAGRAM

  96
• 1 REGULATORY AND SAFETY INFORMATION

  102
  • 1.1 SAFETY SYMBOL CONVENTIONS

    102
  • 1.2 RF ENERGY EXPOSURE AWARENESS AND CONTROL INFORMATION FOR FCC OCCUPATIONAL USE REQUIREMENTS

    102
    • 1.2.1 Federal Communications Commission Regulations

      103
  • 1.3 COMPLIANCE WITH RF EXPOSURE STANDARDS

    103
    • 1.3.1 Mobile Mobile Antennas

      104
    • 1.3.2 Approved Accessories

      104
    • 1.3.3 Contact Information

      104
  • 1.4 REGULATORY APPROVALS

    106
    • 1.4.1 Applicable Type Acceptance/Certification Numbers

      106
    • 1.4.2 FCC Part 15

      106
    • 1.4.3 Industry Canada

      107
  • 1.5 OCCUPATIONAL SAFETY GUIDELINES AND SAFETY TRAINING INFORMATION

    107
  • 1.6 COMMON HAZARDS

    107
  • 1.7 SAFE DRIVING RECOMMENDATIONS

    108
  • 1.8 OPERATING RULES AND REGULATIONS

    108
  • 1.9 OPERATING TIPS

    109
• 2 RENSEIGNEMENTS SUR LA RÉGLEMENTATION ET SÉCURITÉ

  110
  • 2.1 CONVENTIONS SUR LES SYMBOLES DE SÉCURITÉ

    110
  • 2.2 RENSEIGNEMENTS SUR UNE EXPOSITION À L’ÉNERGIE DES RF

    110
    • 2.2.1 Renseignements Sur Le Contrôle Et La Sensibilisation À L’énergie Des RF Pour Les Exigences D’une Utilisation Professionnelle De La FCC

      110
    • 2.2.2 Règlements de la Federal Communications Commission (« Commission fédérale des communications » aux États-Unis)

      111
  • 2.3 CONFORMITÉ AUX NORMES D’EXPOSITION AUX RF

    111
    • 2.3.1 Antennes Mobiles

      114
    • 2.3.2 Accessoires Approuvés

      114
    • 2.3.3 Coordonnées

      114
  • 2.4 INTERFÉRENCE DES RADIOFRÉQUENCES

    115
    • 2.4.1 Partie 15 de la FCC

      115
    • 2.4.2 Industrie Canada

      115
  • 2.5 RENSEIGNEMENTS SUR LA FORMATION SUR LA SANTÉ ET LA SÉCURITÉ AU TRAVAIL

    115
• 3 RELATED PUBLICATIONS

  116
• 4 MARITIME FREQUENCIES

  117
• 5 CATALOG AND PART NUMBERS

  123
• 6 CUSTOMER SERVICE

  124
  • 6.1 CUSTOMER CARE

    124
  • 6.2 TECHNICAL ASSISTANCE

    124
• 7 WARRANTY REGISTRATION

  124