Honeywell International Inc. WFSRM Manuale Utente

34

SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000NF-E:C  5/8/2015

Wireless Devices

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to 
the following two conditions: 

1. This device may not cause interference, and 
2. This device must accept any interference, including interference that may cause undesired 

operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio 
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : 

1. L'appareil ne doit pas produire de brouillage, et 
2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le 

brouillage est susceptible d'en compromettre le fonctionnement.

This device utilizes the Honeywell915 rev A radio module and complies with IFETEL standard(s).

The following are the specifications for the wireless devices.

For information on installing the wireless devices, refer to the documents referenced in Table 1.1.

Device configuration starts with assigning a profile.

To assign a profile, the device must be in a factory default state. A single red light flashes on the 
LED confirming that the device is in the default state. To restore the device to factory default state, 
refer to Section 3.5.4, “Restoring a Device to Factory Default”.

There are two methods to assigning a profile.

Radio Frequency

Lower ISM Band (902-928 MHz)

Maximum power output

+17dBm

Minimum signal strength level needed at the receiver for a primary path 
with weak link trouble reporting enabled.

-55dBm

Minimum signal strength level needed at the receiver for a secondary 
path or primary path with weak link trouble reporting disabled.

Must be 18 dBm higher than the 
noise floor down to -80dBm

Maximum ambient noise level

-85dBm

Minimum battery life

2 years