Honeywell International Inc. WFSRM Manuale Utente

SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000NF-E:C  5/8/2015

37

Wireless Devices

8. Select the device from the Communicator panel.      

9. Click Assign.

The device is now included in the list of devices with a profile assigned. When the profile is 
assigned, the green LEDs turn on steady for 10 seconds.

To turn a device into a distributor: 

1. Power up the device with one battery installed. 
2. Ensure that the device is in the profile modification mode. If the device is in profile 

modification mode, the yellow LED will blink once every 5 seconds. The profile modification 
mode times out if the device has not received a command in one minute.

3. Toggle the SLC address wheel between 0-1-0-1. To toggle the SLC address wheel, use a 

common screwdriver to adjust the rotary switches on the device to:
1. Set the address to 0.
2. Change the address to 1.
3. Change the address back to 0.
4. Change the address back to 1.

To return a distributor device back to a network device, replace the batteries and provide a proper 
SLC address. A normal device requires four batteries for proper operation. It is recommended to 
use fresh batteries after the distributor mode. 

To add a device to a mesh, refer to the topic, "Create a Mesh Network". To form a mesh network, 
ensure that the gateway is powered on and contains a profile. Activate the mesh formation (refer to 
Figure 2.2) magnetic sensor on the gateway.

as

si

gn

pr

of

ile

.p

n

g

assi

gn

pr

of

ile

2

.p

ng

NOTE: Only a device with a profile can be used as a distributor.

NOTE: The green LED blinks every half second when the device is functioning as a distributor.