ICOM 382200 Manuale Utente
15
5
BASIC OPERATION
■ Monitor function
The Monitor function temporarily cancels the Squelch
function to check for weak signals.
function to check for weak signals.
1. Hold down [VOL/SQL] to turn ON the Monitor function.
L
The Monitor function is ON while [VOL/SQL] is held down.
•
is displayed.
• If there is a weak signal, you can hear the signal and noise.
2. Release to turn OFF.
TIP: You can change the Monitor function settings. See
page 55 for details.
page 55 for details.
■ AquaQuake Water Draining
function
Water in the speaker grill may mufle the sound coming
from the speaker. The AquaQuake Water Draining function
removes water from the speaker grill by vibrating the speaker.
from the speaker. The AquaQuake Water Draining function
removes water from the speaker grill by vibrating the speaker.
1.
Push [◄] or [►] to select
.
2. Hold down the software key below
to turn ON the
function.
• A low frequency vibration beep sounds to drain the water,
regardless of the volume level setting.
L This function is activated for a maximum of 10 seconds,
even if you continue to hold down the
software key.
3. Release the key to turn OFF the function.
NOTE: You cannot use this function when an external speaker
microphone is connected.
microphone is connected.
■ Editing a
channel name
You can edit the name of each operating channel and weather
channel, using numbers, uppercase letters, symbols, and
a space. This enables easy recognition of the channels or
stations. All VHF marine channels are set with default names.
channel, using numbers, uppercase letters, symbols, and
a space. This enables easy recognition of the channels or
stations. All VHF marine channels are set with default names.
1.
Push [▲] or [▼] to select the channel to edit.
2.
Push [◄] or [►] to select
.
L You cannot edit a channel name during Dualwatch, Tri-watch,
or a Scan.
3. Push the software key below
.
•
The “Channel Name” screen is displayed.
4. Edit the channel name.
TIP:
• Select [! $ ?] to enter characters, and select [ABC] to enter
numbers and letters.
•
Select characters or space using [▲]/[▼]/[◄]/[►].
• Push [ENT] to enter the selected character.
•
Select “←” or “→,” to move the cursor.
• Push the software key below
to cancel editing.
5. Push the
software key
below [DONE]
to set the edited
name.
below [DONE]
to set the edited
name.