The Watt Stopper Inc. d/b/a Qmotion QMRS-908 Manuale Utente
5
Qadvanced Roller Shade
Z-Wave
Programming Instructions
Read and understand each section before performing required steps
During FIRST TIME SETUP after Step 3. TUG, a Z-Wave Plus controller must be paired to the shade within 90 seconds.
Otherwise, the shade will time-out and require another attempt. JOG is a short up and down movement. A double JOG
from the current position will indicate failure on the device add. The process should be restarted if the expected results
differ or a double jog failure indication is received.
Otherwise, the shade will time-out and require another attempt. JOG is a short up and down movement. A double JOG
from the current position will indicate failure on the device add. The process should be restarted if the expected results
differ or a double jog failure indication is received.
IMPORTANT
FIRST TIME SETUP (Z-Wave ADD)
1. INSTALL SHADE following the shade installation instructions.
2. Place the Z-Wave controller into ADD device mode.
3. Now perform two micro tugs, short pause between them.
__
(Shade will move to Upper Limit Position, then down a small amount)
4. Now perform one short tug and wait for 5 seconds.
__
(Shade will move to Upper Limit Position, then down a small amount)
5. Now the Z-Wave controller will query new device.
(Controller signals that a new device has been discovered)
SETTING LOWER LIMIT (Only if shade has never been added to a controller)
1. Slowly TUG the HEMBAR to the lower limit position
(Controller signals that a new device has been discovered)
SETTING LOWER LIMIT (Only if shade has never been added to a controller)
1. Slowly TUG the HEMBAR to the lower limit position
__
(Shade should move smoothly to fully closed position and remain)
2. From the Z-Wave controller, select the newly added device.
3. Command shade to a position that is NOT On or Off.
3. Command shade to a position that is NOT On or Off.
__
(Shade will move to fully open position, jog and back to full open)
To REMOVE shade from controller (Z-Wave REMOVE)
1. Place the Z-Wave controller into REMOVE device mode.
2. Now perform two micro tugs, short pause between them.
__
(Shade will move to Upper Limit Position, then down a small amount)
3. Now perform one short tug and wait for 5 seconds.
_
(Shade will move to Upper Limit Position, then down a small amount)
4. Now the Z-Wave controller will remove the device.
(Controller signals that a new device has been removed)
(Controller signals that a new device has been removed)