Insys GSM LOGO 4.2 Compact 11-02-01-03-04.001 Manuale Utente
Codici prodotto
11-02-01-03-04.001
INSYS GSM 4.2 LOGO!
HSComm
Dezember 06
33
5.4
Status Bar
The status bar at the bottom of the HSComm window shows the serial interface
settings and activities. RX and TX illuminate synchronously when receiving and
sending data.
settings and activities. RX and TX illuminate synchronously when receiving and
sending data.
5.5
Buttons
5.5.1 Send settings
The current HSComm settings will be transferred to the INSYS GSM 4.2 LOGO!
The settings in the PLC window are only transferred when the Send PLC
configuration
The settings in the PLC window are only transferred when the Send PLC
configuration
button is activated.
5.5.2 Read settings
The current settings of the INSYS GSM 4.2 LOGO! will be read out and displayed in
HSComm.
HSComm.
5.5.3 Send default settings
The factory settings are loaded and a reset is executed. The device then logs in to
the GSM network again if the PIN is stored.
the GSM network again if the PIN is stored.
5.5.4 Reset
Software reset of the INSYS GSM 4.2 LOGO! The device then logs in to the GSM
network again if the PIN is stored.
network again if the PIN is stored.
5.5.5 Synchronize
The serial interface of the INSYS GSM 4.2 LOGO! and the connected device must
be configured the same. When the “Synchronize” button is activated, all possible
settings for baud rate and data format are checked on the PC side until both sides
match.
be configured the same. When the “Synchronize” button is activated, all possible
settings for baud rate and data format are checked on the PC side until both sides
match.
5.5.6 Abort
Cancels an ongoing data transmission (Send settings, Read settings, Send default
settings – indicated by the progress bar over the buttons).
settings – indicated by the progress bar over the buttons).