Benq GP30 9H.JCK77.19E Scheda Tecnica
Codici prodotto
9H.JCK77.19E
Operation
32
Entering the password recall procedure
1.
Press and hold on the remote control for 3
seconds. The projector will display a coded
number on the screen.
seconds. The projector will display a coded
number on the screen.
2.
Write down the number and turn off your
projector.
projector.
3.
Seek help from your local BenQ service center
to decode the number. You may be required to
provide proof of purchase documentation to
verify that you are an authorized user of the projector.
to decode the number. You may be required to
provide proof of purchase documentation to
verify that you are an authorized user of the projector.
Changing the password
1.
Go to the Settings > Advanced > Security Settings > Change password
menu.
menu.
2.
Press OK. The message “Input Current Password” appears.
3.
Enter the old password.
• If the password is correct, another message “Input New Password” appears.
• If the password is incorrect, the password error message displays for three
• If the password is correct, another message “Input New Password” appears.
• If the password is incorrect, the password error message displays for three
seconds, and the message “Input Current Password” displays for you to
retry. You can press to cancel the change or try another password.
retry. You can press to cancel the change or try another password.
4.
Enter a new password.
The digits being input will display as asterisks on-screen. Write your selected password down in
this manual in advance or right after the password is entered so that it is available to you should
you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
Keep this manual in a safe place.
5.
Confirm the new password by re-entering the
new password.
new password.
6.
You have successfully assigned a new password
to the projector. Remember to enter the new
password next time the projector is started.
to the projector. Remember to enter the new
password next time the projector is started.
7.
To leave the OSD menu, press or .