Whirlpool W10038070 Manuale Utente

4. To remove the power cord from the cord restraint, push the

power cord in, press TAB, and then pull the power cord out.

Looped power cord

1. Firmly grasp the yellow shipping strap and pull until both

ends are completely removed from washer.

2. Check that two (2) cotter pins were removed with the

shipping strap.

Connect Drain Hose

Proper connection of the drain hose protects your floors from
damage due to water leakage. Read and follow these instructions.
The drain hose is connected to your washer and is stored inside
the washer cabinet.

Remove drain hose from washer cabinet

Gently pull the corrugated drain hose out of the washer from the
top of the hose. Continue to pull the hose until the end emerges.
Do not force excess drain hose back into the rear of the washer.

Laundry tub drain or standpipe drain

Connecting the drain hose form to the corrugated
drain hose

1. Feed end of drain hose into one end of form. Place end of

drain hose form into the drain hose relief.

2. Bend the hose over the top of the form and feed into the

other end of the form.

If drain hose does not fit into standpipe or if placing over
the edge of a laundry tub:

■

Place coupling on end of drain hose. Use a screwdriver to
install hose clamp.

■

Then slide the second hose clamp onto coupling. Insert end of
adapter into coupling. Use a screwdriver to install second
hose clamp over coupling.

To keep drain water from going back into the washer:

■

Do not force excess drain hose into standpipe. Hose should
be secure but loose enough to provide a gap for air.

■

Do not lay excess hose on the bottom of the laundry tub.

Looped power cord

A. Drain hose reliefs