Whirlpool W10038070 Manuale Utente

Pagina di 16
14
Floor drain
Do not install the drain hose form on to the corrugated drain hose. 
You may need additional parts. See Floor drain under “Tools and 
Parts.”
Connect the Inlet Hoses
The washer must be connected to the water faucets using the 
new inlet hoses. Do not use old hoses.
Insert new flat washers (supplied) into each end of the inlet hoses. 
Firmly seat the washers in the couplings. 
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
1. Attach the hose labeled hot to the hot water faucet. Screw 
on coupling by hand until it is seated on the washer.
2. Attach the hose labeled cold to the cold water faucet. Screw 
on coupling by hand until it is seated on the washer.  
3. Using pliers, tighten the couplings with an additional 
two-thirds turn. 
NOTE: Do not overtighten or use tape or sealants on the 
valve. Damage to the valves can result.
Clear the water lines
Run water through both faucets and inlet hoses, into a laundry 
tub, drainpipe or bucket, to get rid of particles in the water 
lines that might clog the inlet valve screens.
Check the temperature of the water to make sure that the hot 
water hose is connected to the hot water faucet and that the 
cold water hose is connected to the cold water faucet.
Connect the inlet hoses to the washer  
1. Attach the hot water hose to the bottom inlet valve. 
2. Attaching the hot water coupling first makes it easier to 
tighten connection with pliers. 
3. Screw on coupling by hand until it is seated on the washer. 
4. Using pliers, tighten the couplings with an additional 
two-thirds turn. 
NOTE: Do not overtighten or use tape or sealants on the 
valve. Damage to the valves can result. 
5. Attach the cold water hose to the top inlet valve. 
6. Screw on coupling by hand until it is seated on the washer. 
7. Using pliers, tighten the couplings with an additional 
two-thirds turn. 
NOTE: Do not overtighten or use tape or sealants on the 
valve. Damage to the valves can result.
Check for leaks
Turn on the water faucets and check for leaks. A small amount of 
water might enter the washer. You will drain this later.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk 
of hose failure. Record hose installation or replacement dates for 
future reference.
If you connect only one water hose, you must cap off the 
remaining water inlet port.
Periodically inspect and replace hoses if bulges, kinks, cuts, 
wear, or leaks are found.
A. Coupling
B. Washer
Tighten the couplings with an additional two-thirds turn. 
A
B
A. Cold water inlet valve
B. Hot water inlet valve
A
B