Whirlpool W10038070 Manuale Utente

1. Remove the shipping strap from the power cord. Drape the 

power cord over the console.

2. Remove any cardboard used to move washer.

3. Wrap the drain hose to the laundry tub leg or drain standpipe 

with the beaded tie strap. Push fastener into the nearest hole 
in the beaded tie strap. See view A or B.

If the washer faucets and the drain standpipe are recessed, 
put the formed end of the drain hose into the standpipe. 
Tightly wrap the tie strap around the water inlet hoses and the 
drain hose. See view C.

Properly leveling your washer avoids excessive noise and 
vibration.

1. Prop up the front of the washer about 10.2 cm (4") with a 

wood block or similar object. The block needs to support the 
weight of the washer.  

2. Screw the locknut onto each foot to within 2.5 cm (1") of the 

foot base. 

3. Screw the feet into the threaded holes at the front corner of 

the washer until the nuts touch the washer. Twist the feet to 
install.

NOTE: Do not tighten the nuts until the washer is level. 

4. Tilt the washer back and remove the wood block. Gently 

lower the washer to the floor.

1. Slide the washer to its final location.

2. Tilt the washer forward until the rear of the washer is at least 

10.2 cm (4") off the floor. You may hear the self-adjusting rear 
feet click into place. Lower the washer to the floor.  

3. Check the levelness of the washer by placing a level on the 

top edges of the washer, first side to side, then front to back. 

C

B

A

A

A