NEC EXPRESS 5800 Manuale Utente

 

Use the following procedure to set up and perform a clean Windows 2000 Operating System
installation on your server.

Insert the Windows 2000 CD into the CD-ROM drive and boot your system by pressing
CTRL+ALT+Delete.

: Perform Steps 2 through 6 if a RAID controller is installed in

your server; go to Step 7 if your server does not include a RAID controller.

While the message “Setup is inspecting your computer’s hardware configuration” or a solid
blue background is displayed on the screen, press the F6 key.

 There is no visible indication on the screen when the F6 key

has been pressed.

When the following message is displayed, press S.
 “Setup could not determine the type of one or more mass storage devices installed in your
system, or you have chosen to manually specify an adapter”. Currently, Setup will load support
for the following mass storage devices.

When the following message is displayed, select “Other” and then press Enter.
Select the SCSI Adapter your want from the following list, or select "Other" if you have a
device support disk provided by an adapter manufacturer

Insert the "Windows 2000 OEM-DISK" diskette into the floppy drive, and press Enter. A list of
mass storage devices is displayed.

Select the RAID disk array controller installed in your server from the list of mass storage
devices.

Follow the messages on the screen to continue to install.

 Please consult the Microsoft Windows 2000 Installation Guide

for more extensive installation procedures.

For LAN adapter driver installation, see Installing LAN Adapter Drivers later in
this appendix.

After installing Windows 2000, logon to the system using the administrator account or other
account, which is a member of the Administrator’s group.