NEC EXPRESS 5800 Manuale Utente

Insert the EXPRESSBUILDER CD and run the “Windows 2000 NEC Update Module” for the
Express5800 120Rb-1 Server.

 If you change the configuration of the system (by adding or

removing hardware or operating system software components), or repair the
system, you must run the Windows 2000 NEC Update Module again.

 LAN Adapters

The following section includes special driver installation instructions for the Intel PRO/100+ LAN
adapter used in your system.

The PRO/100+ driver is initially installed during the installation of Windows 2000 and upgraded when
you run the “Windows 2000 NEC Update Module, see “Installing Microsoft Windows

®

 2000 Operating

System” found earlier in this appendix. In order to utilize the PRO/100+ LAN adapter “teaming
features,” use the following procedure to install “PROSET II for Windows 2000.”

Power on, start Windows 2000, and log on.

Insert the EXPRESSBUILDER CD into the CDROM drive. The “Start” Menu displays.

Select “Drivers and Utilities” from the “Start” Menu.

Select INTEL.

Select and run “PROSET II for Windows 2000.”

 the ATI RAGE XL Display Adapter

To take full advantage of the on-board ATI RAGE XL display adapter, perform the following driver
installation procedure:

Power on, start Windows 2000, and log on.

Insert the EXPRESSBUILDER CD into the CDROM drive. The “Start” Menu displays.

Select “Drivers and Utilities” from the “Start” Menu.

Select ATI.

Select and run “Rage XL Driver for Windows 2000.”

XX