NEC EXPRESS 5800 Manuale Utente

 RAID

If you have a Disk Array Controller preinstalled on your system, it was preconfigured at the factory.
Refer to your system's User's Guide and to the AcceleRAID Installation Guide and the Disk Array
Controller Installation Guide and User’s Manual for additional information on this option card. If you
need to change the RAID level from the factory setting, you must change the setting before installing
the operating system.

Use this procedure to install Windows NT 4.0 Operating System.

Insert the Windows NT CD into the CD-ROM drive and boot your system by powering on the
system.

While the message “Setup is inspecting your computer’s hardware configuration” or a solid
blue background is being displayed on the screen, press the F6 key.

 There is no visible indication on the screen when the F6 key

has been pressed.

When the following message is displayed, press S.
 “Setup could not determine the type of one or more mass storage devices installed in your
system, or you have chosen to manually specify an adapter”. Currently, Setup will load support
for the following mass storage devices.

When the following message is displayed, select “Other,”  then press Enter.
Select the SCSI Adapter your want from the list, or select "Other" if you have a device support
disk provided by an adapter manufacturer

Insert the "Windows NT 4.0 OEM-DISK #1" diskette into the floppy drive, and press Enter.

A list of mass storage devices is displayed.
Select "Adaptec Ultra160/m Family PCI SCSI Controller", and press Enter.

When you are using a disk array controller, select the appropriate "device controller" from the
above list of mass storage devices.

Follow the message on the screen to continue to install.

IMPORTANT: Please consult the Microsoft Windows NT 4.0 Installation Guide
for more extensive installation procedures.

IMPORTANT: For LAN adapter driver installation, see Installing LAN Adapter
Drivers later in this appendix.