Lightwave Communications SCS3230 Manuale Utente
ConsoleServer 3200 System
Lightwave Communications
Rev. A
- 68 -
www.lightwavecom.com
CONNECTIONS command is used alone. (See section 6.8, Sys Admin Session Management
Commands).
Commands).
The
CONNECTIONS command will also tell the sys admin which terminal ports are
present (in the list, they are referred to as "channels"). If the port is not functioning (i.e.,
the card is not present or there is a fault with the individual port), the port will be listed
as "
the card is not present or there is a fault with the individual port), the port will be listed
as "
<not installed>". It will also list Telnet Active for an active Telnet session.
7.9.2
LISTCARDS Command
Sys admin>>LISTCARDS
Installed cards
Slot A : <card not installed>
Slot B : Terminal card installed
Slot C : Terminal card installed
Slot D : Terminal card installed
Slot E : Terminal card installed
Slot F : Switch card 1 installed
Slot G : Switch card 2 installed
Slot H : Device card installed
Slot I : Device card installed
Slot J : Device card installed
Slot K : Device card installed
Slot L : Device card installed
Slot M : Device card installed
Slot N : Device card installed
Slot O : Device card installed
sys admin>>
The
LISTCARDS command will simply tell the sys admin which cards are plugged into
the SCS3230 chassis. It only lists the cards (by type) as present or not present, and
does not indicate whether the cards are functioning properly.
does not indicate whether the cards are functioning properly.
7.9.3
VERSION Command
sys admin>>VERSION /ALL
SCS3230
Slot B1: V2.15 10/01/99 Terminal Boot V1.62 (Sep 30 1999) (14:33:12)
Slot C1: V2.15n 10/01/99 Net Terminal Boot V1.62 (Sep 30 1999) (12:44:32)
Slot C2: V1.16 Build 7 09/29/99 Network Boot V1.62 (Sep 30 1999) (14:45:52)
Ethernet Address: 00-30-31-00-01-D5
Slot F1: V 1.03 Switch 1
Slot G1: V 1.03 Switch 2
Slot H1: V2.15 10/04/99 Device Boot V1.62 (Sep 30 1999) (14:40:51)
Slot P1: V2.12 Build 15 10/01/99 Control Boot V1.62 (Oct 01 1999) (11:13:06)
sys admin>>
By itself, the
VERSION command lists the boot and flash software version for the control
card. The version information for a single card other than the control card may be
displayed by typing the card slot letter ID after the
displayed by typing the card slot letter ID after the
VERSION command. If the sys admin