Lenoxx Optima 3 FS Manuale Utente

PAGE 10 

REMOVING APPLIANCE FROM PALLET 
1.  After removing the packaging from the stove, lift the hop-

per lid, and remove all pre-packaged items that were 
shipped in the hopper. Next, open the stove door and 
remove all pre-packaged items.  

2.  Using a socket or open end wrench (7/16" for freestand-

ing units and 3/8" for the insert), remove the pallet bolts 
which secure the unit to the pallet (located on each side 
of back corners and at the front under ash pan). See fol-
lowing pictures.  

 

 

 

  

Note: The pallet bolt at the front of appliance is located un-
der the ash pan (this will require removing the ash pan. See 
Ash Pan on pages 28 and 29 for removal instructions). See 
following picture (freestanding unit shown). 

 

 

It is strongly recommended that you have an author-
ized Lennox Hearth Products dealer install your 
stove. If you install your stove yourself, you should 
review your installation plan with an authorized Len-
nox Hearth Products dealer. 
 
Check list: 
Check off each item as you proceed with the installa-
tion process. 

 

Read the ENTIRE stove installation section first 

 

Read the Insert or Freestanding section (which-
ever applies). 

 

Determine the appropriate measurements and 
locations for your installation. 

 

Follow the general installation directions under 
Stove Installation and the installation section ap-
propriate to your stove. 

 

Be sure to pre-fit all items before you install, fas-
ten, or set up the stove permanently. 

 

Review the Important Warnings section (page 2). 

 

Review Fuel Specifications (page 27). 

 

Review and follow instructions in the Care and 
Operation Section (pages 22 to 27). 

 

Plug power cord connector into corresponding 
connector on the back of appliance (see illustra-
tions on page 13 showing connector locations). 

 

Note: Optima 3 INS – Route power cord behind 
side surround panel. 

 

Review the routine cleaning / maintenance informa-
tion. 

 

Enjoy the warmth from your new Lennox Hearth 
Products pellet stove! 

 
(Insert Only) It is important to level the appliance.  In 
some installations such as a recessed firebox floor (if 
the existing fireplace floor is lower than the hearth), 
install the 2 leveling bolts (1/4-20 x 3” long) into the 
threaded holes at the rear base of the Optima 3 INS. 
Adjust bolts until appliance is level.