Laser beta lasermike LS8000-3 Manuale Utente
LaserSpeed 8000-3 Instruction Handbook
Installing the System
Part No. 93463 / Drawing No. 0921-01561
Page 20 of 221
Revision A (Sep 2007)
Twinner Lines
When mounting the gauge on a twinner line, the gauge should be positioned
far enough from the twinner that the twist is set. If the gauge is placed close to
the twinner, it may not be able to measure due to excessive vibration and the
spin imparted on the wire due to the twisting motion. Moving the gauge down
the line farther from the twinner may improve the gauge's ability to make
measurements.
far enough from the twinner that the twist is set. If the gauge is placed close to
the twinner, it may not be able to measure due to excessive vibration and the
spin imparted on the wire due to the twisting motion. Moving the gauge down
the line farther from the twinner may improve the gauge's ability to make
measurements.
Line Movement
Near Twinner
Wires spin and
corkscrew (make it
corkscrew (make it
look like wires are
not moving)
Near Takeup
Twist is set, wires not
spinning or corkscrewing.
spinning or corkscrewing.