Hunter Engineering Quick Tread Foglio Delle Specifiche
Quick Check Drive Under with Quick Tread
Surface Mounted
Continued on Page 2
Form 6894-T, 02-15b
Copyright © 2015, Hunter Engineering Company
Drive Under Quick Check and Quick Tread Installation
(shown with optional monitor.)
For inspection information visit:
www.hunter.com/inspection
For local contact visit:
www.hunter.com/company/findrep.cfm
For general inquiries visit:
www.hunter.com
or call
800 448-6848
Site Specifications
Power Requirements
115/230v, 15 amp
*
50/60 Hz 1 ph
Ɨ
Air Supply Req. (IS Units)
90-150 PSI (6.2-10.3 bar)
Approximate Air
Consumption
25 SCFM @ 90 PSI
(648 Lpm @ 6.2 bar)
Min. Concrete Spec.
3 in. (76 mm) thick,
3000 PSI (20,700kPA) rating
Grout Spec.
only required when needed to level sensors
Max. Longitudinal Slope
1/4 in. per ft. (21 mm/m)
Max. Lateral Slope
1/16 in. per ft. (5 mm/m)
Pedestal Location
36-96 in. (914-2438 mm) from QT1
Product Specifications
Max. Wheel Weight
3500 lb. (1588 kg) per wheel
Test Entry Speed
2 to 8 mph (3-13 km/h)
Shipping Weight
Quick Check Cabinet
290 lbs (132 kg)
Quick Check Drive Under
Sensor
316 lbs (143 kg)
Quick Tread
530 lbs (241 kg)
*
Amperage shown is minimal circuit rating.
Ɨ
Isolated ground recommended.
See 6778-T for complete site specifications.
OVERALL FOOTPRINT
END OF BAY
TO FRONT
WHEEL STOP:
120 in.
SENSOR
HEIGHT:
10 FT.
RECOMMENDED
BAY LENGTH
29 ft. 8 in.
OPTIONAL
PEDESTAL
LOCATION
4 in.
15 ft.
RECOMMENDED BAY
WIDTH
TYPICAL 165 in.
(ACCOMODATES
VEHICLES WITH
MAXIMUM
OF 165 in.
WHEELBASE.)
67 in.
QUICK TREAD COMMUNICATION CABLES (UP TO 75 ft.)