Futaba 10CAG Manuale Istruttivo

33

PARAMETER

submenu: sets those parameters you would likely set once, and then not disturb again. 

Once you have selected the correct model you wish to work with, the next step is setting up the proper parameters for this 
VSHFL¿FPRGHO

• What is the model's type? 
• What type is the receiver’s modulation [2.4G-10CH or 2.4G-7CH]?
• Does the model have a normal throttle on channel 3 or do you need full range 

trim on channel 3 (ATL)?

• (GLID only): The separate THR-REV settings for each model can be set.

First it is important to clear out any old settings in the memory from prior use, 
using the MODEL RESET.
MODEL RESET

: completely resets all data in the individual model you have 

currently selected. Don't worry - there is no way you can accidentally delete all 
models in your radio with this function. Only a service center can completely 
reset your radio's entire memory at once. To delete each model in your radio's 
memory (for example when selling), you must SELECT each model, reset that 
memory, then go SELECT the next memory, etc. 

Note that when you COPY one model memory into another or change the model's type, you need not delete all existing data 
¿UVWE\XVLQJWKLVIXQFWLRQCOPY completely overwrites anything in the existing model memory, including MODEL NAME.
The MODEL TYPE function overwrites all data except name and MODUL.

Reset model memory 1. 

Confirm you are currently using the 
proper model memory. (Ex: 1)

On home screen, check model name and 
number on top left. If it is not correct, 
use MODEL SELECT, p. 30.

Open PARAMETER submenu.

for 1 second.

 (If ADVANCE,

again.)

to 2nd page of menu. 

to PARAMETER.

Reset the Memory.

for one second.

&RQ¿UPWKHFKDQJH

Are you sure?

 displays. 

*

Close.

Now that the memory is reset, name has returned to the default (Ex: 
MODEL-0001

).

NAME

 the model: p. 32.

COPY

 a different model into this memory: p. 31. 

SELECT

 a different model to edit or delete: p. 30. 

Change the MODEL TYPE to glider or helicopter: see p. 34. 
Change the receiver modulation [2.4G-10CH or 2.4G-7CH]: see p. 35. 
Utilize servo REVERSE: see p. 38. 
Adjust servo travel with END POINT: see p. 39. 
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDOD/R,EXP): see p. 42.

*Radio emits a repeating “beep” and shows progress on screen as the model memory is being reset. Note that if the power switch is turned off prior to 

completion, the data will not be reset.