Fusion Electronics Automobile Alarm CE-99200 Manuale Utente

6 Pin Mini Connector

Black Antenna Wire

LED Indicator

Valet Switch

Main 6 Pin Wire harness

6 Pin Door Lock/Unlock

     

Wire harness

6. Red Wire: +12V To Constant Battery Source

5. Brown Wire: Positive output To Siren

4. Black Wire: Ground to Vehicle FRAME

1. White Wire: Turn Indicator Relay Output

2. Red / Blue Wire: Turn Indicator Relay Power input

3. White Wire: Turn Indicator Relay Output

1.  Turn the ignition ‘switch ‘ON/OFF’ 3 times (within 15 seconds) and  
 

leave in the OFF position. 

2.  Push the valet switch 6 times and hold on the 6th push until three  
 

short chirps and one long chirp is heard, and then release the valet  

 

switch. You are now in the alarm feature ‘Shock Sensor’ 

 programming 

mode.

3.  Press and hold   button for 2 seconds. One long siren chirp will  
 

indicate the unit is ready to accept adjustments of the second stage  

 

of the shock sensor (full alarm).

4. Pressing the   button on the remote once will decrease the sensitivity  
 

level by one, each time a decrease is made the siren will respond

 

with one chirp, while 2 chirp’s indicates the minimum sensitivity 

 setting.

5. Pressing   button on the remote once will increase sensitivity level by  
 

one, each time an increase is made the siren will respond with  

 

one chirp, while 2 chirp’s indicates the maximum sensitivity setting.

6.  Hit the bumper or strong metal part of the vehicle to test the 
 

threshold level of the sensor. 

 

a). Activate the warn-away (first stage of the shock sensor), the siren  

 

will emit a short chirp.

 

b). Activate the full alarm (second stage of the shock sensor), the  

 

siren will emit a long chirp.

7.   When you are satisfied with the second stage of the shock sensor 
 

settings, press and hold   and   buttons simultaneously for 

 

2 seconds. Two long siren chirps will indicate the unit is ready  

 

to accept adjustments of the first stage of the shock 

 sensor 

(warn-away).

8.   Follow the steps 4, 5 and 6 to adjust the warn-away sensitivity.

9.   When you are satisfied with the setting, press   and   buttons 
 

simultaneously. One long siren chirp indicates the unit has confirmed  

 the 

setting.

Note: If 20 seconds of inactivity expire, or the ignition is turned on during 
the above steps, the unit will exit the programing mode and return to the 
disarmed mode. Three long chirps will confirm exit.