Digidesign Control 24 Manuale Utente

AutoMatch Function

During playback, you can stop writing of auto-
mation on Write-enabled or Latch-enabled 
tracks and return automation to previously writ-
ten levels by ramping up or down according to 
the AutoMatch time.

To end an automation pass on a single Write- or 
Latch-enabled track with AutoMatch:

■

During playback, at the point where you want 

to stop writing automation on a track, press the 
AUTO switch on its channel.

To end an automation pass on all tracks with 
AutoMatch:

■

During playback, at the point where you want 

to stop writing automation, hold 

OPT(ALT)/ALL

 

and press the AUTO switch on a Write- or Latch-
enabled channel.

Snap Back Function

During playback, you can stop writing of auto-
mation on Write-enabled or Latch-enabled 
tracks and return automation instantly to previ-
ously written levels, ignoring any AutoMatch or 
AutoGlide settings.

To end an automation pass on a single Write- or 
Latch-enabled track with Snap Back:

■

During playback, at the point where you want 

to stop writing automation on a track, hold 

(CTL)

 and press the AUTO switch on the chan-

nel.

To end an automation pass on all tracks with Snap 
Back:

■

During playback, at the point where you want 

to stop writing automation, hold 

(CTL)+OPT(ALT)/ALL 

and press the AUTO switch 

on a Write- or Latch-enabled channel.

Join Function

The Join function is used in Latch mode to man-
ually resume writing of automation after the 
transport is stopped and started again during an 
automation pass. 

To manually resume writing automation in Latch 
mode:

1  

After writing an automation pass, stop the 

transport. The master LATCH switch flashes 
when the automation for one or more controls 
can be resumed in Latch mode.

2  

Move the cursor back so that it is just before 

the stop location.

3  

Resume playback.

4  

At the point where you want to start writing 

automation, hold 

(CTL)

 and press the flashing 

master LATCH switch.

Automation recording continues for all controls 
in Latch mode.

AutoJoin Function

The AutoJoin function is used in Latch mode to 
automatically resume writing of automation af-
ter the transport is stopped and started again 
during an automation pass.

To automatically resume writing automation in 
Latch mode:

1  

After writing an automation pass, stop the 

transport. The master LATCH switch flashes 
when the automation for one or more controls 
can be resumed in Latch mode.

2  

In the Automation Enable window, click the 

AutoJoin button. A red line, the AutoJoin Indi-
cator, appears in the Edit window to show the 
stop location.