Digidesign Control 24 Manuale Utente

QuickStart System Test

This section takes you through a basic system 
test to make sure that hardware, software, and 
connections are all configured and functioning 
properly. The test employs the Demo Session 
that is included on the Pro Tools Installer disc.

To begin:

■

Launch Pro Tools and open the Demo Ses-

sion, or any available session. 

To play a session:

1  

Adjust the monitor output level from the 

Control Room Monitor section, using the 
Main Monitor Level knob to start with the vol-
ume low enough to avoid any ear or speaker 
damage. 

2  

Press PLAY on the Control|24 Transport.

3  

Adjust the main volume using the 

Main Monitor Level knob.

4  

To stop playback, press STOP (or press the 

Space bar of your computer keyboard). 

If you weren’t able to play and hear the session, 
refer to “Troubleshooting” on page 38. 

Setup and Configuration 
Options

Control|24 provides the following monitoring 
modes and options, listed below with a descrip-
tion of the default (factory) settings.

For instructions on settings for the Control 
Room Monitor Section, see Appendix B, “Utility 
Functions” and Chapter 8, “Control Room 
Monitor Section.”

Stereo, Single-Source 
Input/Monitoring

In this mode, only one single stereo input 
source can be monitored through Control|24 at 
a time. This is also known as X-Or selection. 

Internal Talkback (Built-In Talkback Mic) 

In this mode, the built-in Talkback mic supplies 
input to the Control|24 Talkback buss. 

Monitoring Modes

Control|24 provides selectable stereo and sur-
round monitoring modes. See Chapter 8, “Con-
trol Room Monitor Section” for more informa-
tion about these modes.

To select Stereo or Surround Monitoring Modes:

 

■

 

Press one of these three MONITOR MODE 

switches in the Control Room Monitor section:

• STEREO

• LCRS

• 5.1