Extreme networks 4700 Manuale Utente

Altitude 4700 Series Access Point Installation Guide

To mount the access point on a wall using the provided template: 

Photocopy the template (on the previous page) to a blank piece of paper. Do not 
reduce or enlarge the scale of the template. 

Tape the template to the wall mounting surface.

●

If the installation requires the antenna be positioned vertically, the centerline 
reference (of the template) needs to be positioned vertically. The cabling shall exit 
the access point in a vertical direction.

●

If the installation requires the antenna be positioned horizontally, the vertical 
centerline (of the template) needs to be positioned horizontally. The cabling shall 
exit the access point in a horizontal direction.

At mounting targets A and B, mark the mounting surface through the template at 
the target center.

Discard the mounting template.

At each point, drill a hole in the wall, insert an anchor, screw into the anchor the 
wall mounting screw and stop when there is 1mm between the screw head and the 
wall. 

If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are 
going directly into the wall and 6mm (0.23in.) if wall anchors are being used.

If required, install and attach a security cable to the access point lock port.

Attach the antennas to their correct connectors.

For information on available antennas, see 

.

Place the large center opening of each of the mount slots over the screw heads.

Slide the access point down along the mounting surface to hang the mount slots on 
the screw heads.