Extreme networks 4700 Manuale Utente

Altitude 4700 Series Access Point Installation Guide

The access point is ready to configure. For information on basic access point device 
configuration, see 

.

A suspended ceiling mount requires holding the access point up against the T-bar of a 
suspended ceiling grid and twisting the access point chassis onto the T-bar.

The mounting tools (customer provided) and hardware required to install the access 
point on a ceiling T-bar consists of:

●

Safety wire (recommended and customer supplied) 

●

Security cable (optional and customer supplied)

To install the access point on a ceiling T-bar:

Extreme Networks recommends you loop a safety wire — with a diameter of at least 
1.01 mm. (.04 in.), but no more than 0.158 mm (.0625 in.) — through the tie post 
(above the access point’s console connector) and secure the loop.

If desired, install and attach a security cable to the access point lock port.

Attach the antennas to their correct connectors.

For information on the antennas available to the access point, see 

.

Cable the access point using either the Power Injector solution or the power supply.

For Power Injector installations:

Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data 
supply (host) and the Power Injector Data In connector.

Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the Power Injector 
Data & Power Out connector and the access point’s GE1/POE port.

Ensure the cable length from the Ethernet source to the Power Injector and access 
point does not exceed 100 meters (333 ft). The Power Injector has no On/Off