Desa CB36P ユーザーズマニュアル
www.desatech.com
117437-01D
13
4.. Connect.one.wire.from.receiver.to.male.
connector.on.high.limit.harness.and.one.
to “TH” on control valve (see Figure 14,
page.1).
to “TH” on control valve (see Figure 14,
page.1).
5.. Locate.two.plastic.mounting.clips.provided.
with.kit.
6. Use clips to mount receiver on remote
mounting.bracket.as.shown.in.Figure.16.
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1.. Remove.battery.cover.on.back.of.remote.
Held Remote Control Unit
1.. Remove.battery.cover.on.back.of.remote.
control.unit.
.. Attach.terminal.wires.to.a.9-volt.alkaline.
battery.(not.included)..Place.battery.into.
battery.housing.(see.Figure.17).
battery.housing.(see.Figure.17).
3.. Replace.battery.cover.onto.remote.con-
trol.unit.
INSTALLING OPTIONAL CONTROLS
Continued
9-Volt.
Battery
Battery
Battery.
Housing
Housing
Battery.
Cover
Cover
Terminal.
Wires
Wires
Remote.
Control.
Unit
Control.
Unit
Towards Front
REMOTE ON OFF
Figure 16 - Mounting Remote Receiver to
Bracket
Figure 17 - Installing Battery in Hand-
Held Control Unit (HRC100 Series)
Figure 18 - Installing WRC Remote Receiver
Figure 19 - Installing Battery into Back of
Handset
Fireplace.
Receptacle
Receptacle
Remote.
Control.
Receiver
Control.
Receiver
Extension.Cord
Ignition.
Module.
Plug
Module.
Plug
Pull.to.
Remove.
Insulation.
Tab
Remove.
Insulation.
Tab
Battery.Cover
1.Volt.Battery
Back.of.Handset
Plastic.Mounting.
Clips
Clips
Remote.Receiver
INSTALLING OPTIONAL WIRELESS
REMOTE CONTROL - MODEL WRC
(Electronic Ignition)
REMOTE CONTROL - MODEL WRC
(Electronic Ignition)
Installing and Activating the Remote
Receiver
1.. Open.bottom.louver.and.locate.plug.re-
Receiver
1.. Open.bottom.louver.and.locate.plug.re-
ceptacle..Plug.receptacle.is.located.either.
on.right.or.left.side.of.cabinet.
on.right.or.left.side.of.cabinet.
.. The.WRC.model.receiver.does.not.require.
a. battery.. Receiver. can. be. installed. by.
first plugging short extension cord into
fireplace receptacle. Then plug receiver
unit.into.extension.cord..Finally.plug.igni-
tion. module. plug. into. receiver. unit. (see.
Figure.18).
first plugging short extension cord into
fireplace receptacle. Then plug receiver
unit.into.extension.cord..Finally.plug.igni-
tion. module. plug. into. receiver. unit. (see.
Figure.18).
3.. Activate. remote. handset. battery. by. re-
moving.insulating.tab.on.back.of.handset.
(see.Figure.19)..Battery.is.included.pre-
installed.
(see.Figure.19)..Battery.is.included.pre-
installed.
4.. Once.battery.is.activated.unit.is.ready.to.
use.
5.. Replace.bottom.louver.panel.