Friedrich 920-087-09 ユーザーズマニュアル

16

1.  Remove the weatherboard and center support from the sleeve (if 

still in place). Be sure an outdoor grille is attached.

NOTE: 

Use a wall sleeve adapter kit (PXSE) if installing a P-Series 

chassis in a T-Series sleeve.

2.  Remove the front cover contained in a protective plastic bag 

from  chassis.    Remove  the  bag  and  dispose  of  it  properly.  

 

If the control door is not installed, follow these steps:

a.  From the front cover, slide the right control door pin into the 

hole on the right side of the front cover.

b.  Slide the left door pin into the hole on the left side of the 

front cover opening.

c.  Snap cover into place.

NOTE: 

To avoid breaking the door or hinge pins, do not apply excessive 

force when installing.

IMPORTANT:  When installing a Friedrich PTAC into an existing sleeve, 

it is important to ensure that the unit is installed completely.  Inspection 

of the air seal between the condenser air baffles and around the indoor 

mounting flange is recommended.
In some cases additional gaskets or baffling may be required.

Keep bag away from babies and children.

Do NOT use in cribs, beds or playpens.

Destroy immediately after opening. This bag

is NOT a toy.

Failure to do so can result in personal injury

and/or death.

FRP015

WALL SLEEVE

WEATHERBOARD

CENTER SUPPORT

FRP016

PIN

INSERT PIN
IN THIS LOCATION

CONTROL
DOOR