Friedrich 920-087-09 ユーザーズマニュアル

3. Route the cut ends of harness through the conduit connector

assembly and flex conduit sleeve. Be sure to use the supplied

conduit bushing to prevent damage to the cord by the conduit.

The cord should pass through the Locknut, Spacer, Chassis

Junction Box, Conduit Connector, Bushing, then the Conduit

Sleeve. See Figure 17.

4. Route the cut ends of the power cord through the elbow connector

at the other end of the conduit. Tighten screws on elbow connector

to secure conduit sleeve.

5. Fasten and secure the elbow connector to the wall junction box

cover with locknut. Place and mount the wall junction box with

the four wall mounting screws making sure to pass the wall lines

through the junction box. Connect and join all wall lines with the

stripped ends using wire nuts. Tighten both screws of the wall

junction box cover to junction box.

6. Follow steps 4-6 on page 19 and refer to Figure 27.

Figure 15

Figure 16

Figure 17

FRP032

4.0 IN.

18.0 IN.

TRIM HARNESS
TO LENGTH

STRIP WIRE ENDS (0.5 IN.)

TO WALL JUNCTION

TO CHASSIS JUNCTION

EXPOSE
WIRES
(1.0 IN.)

FRP033

GROUND
SCREW

GROUND
WIRE

HARNESS

JUNCTION
BOX

WALL CONNECTION

JUNCTION
BOX COVER

COVER
SCREWS

STRAIGHT
CONNECTOR

FRP034

LOCKNUT

SPACER

BUSHING

LEADING SIDE FOR

WIRE HARNESS INSERTION

EXITING SIDE FOR

WIRE HARNESS

CHASSIS
JUNCTION
BOX

CONDUIT
CONNECTOR

CONDUIT
SLEEVE