Regency F39-LPG ユーザーズマニュアル

Regency

®

 F39 Room Sealed Freestanding Gas Stove

A wall thermostat may be installed if desired. 
Connect the wires as per the wiring diagrams. 
Note that the wires are  connected to the "TH" 
on the gas valve. Use table below to determine 
the maximum wire length:

Regency

®

 offers an optional programmable 

thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or 
UL approved may be used.

Use the Regency

®

 Remote Control Kit  approved 

for this unit. Use of other systems may void 
your warranty.

The remote control kit comes with a hand held 
transmitter, a receiver and a wall mounting 
plate.

1)  Choose a convenient location on the wall 

to install the receiver and the receptacle 
box (protection from extreme heat is very 
important). Run wires from the fi replace to 
that location, use Thermostat Wire Table.

2)  Connect the wires as per the wiring diagram 

above.

14 GA.
16 GA.
18 GA.
20 GA.
22 GA.

 15.24  m
 9.75  m
 6.10  m
 3.66  m
 2.71  m

Wire Size                       Max. Length

1)  Open the two side panels.

2)  Slide the door 

onto the two hinge 
pins making sure 
the two pieces 
are fl ush togeth-

er.  

See diagram 1.

4)  The latches should already be at the proper 

setting.  If they are too hard or too easy 
to close, you may want to adjust them by 
loosening the latch catch.  See diagram 3.

5)  Remove the blue plastic protective coating 

from the glass. 

6)  Test the seal around the door by placing 

a piece of paper between the unit and the 
door, close the door and try to pull the paper 
out. If it slips out easily, then the door is not 
properly sealed. Tighten or loosen the latch.  
See diagram 3.

3)  Close the door. 

The latch plate 
must be cen-
tered around the align-
ment pin.  See diagram 
2.  If the latch plate 
interferes with the cor-
ner of the stove you 
may want to angle the 
plate slightly so the door 
closes easier.

3)  Install 3 AAA alkaline batteries in transmitter 

and 4 AA alkaline batteries in  the receiver. 
Install the receiver and its cover in the wall. 
Switch the  remote receiver to "remote" 
mode. The remote control is now ready for 
operation.

Before leaving this unit with the customer, the 
installer must ensure that the appliance is fi ring 
correctly. This includes:

1)  Clocking the appliance to ensure the cor-

rect fi ring rate (rate noted on label) at 15 
minutes.

2)  If required, adjusting the primary air to ensure 

that the fl ame does not carbon. First allow 
the unit to burn for 15 min. to stabilize.

3)  Check for proper draft.