Regency U39-LP1 ユーザーズマニュアル

Regency

®

 U39 ULTIMATE Direct Vent Freestanding Gas Stove

7)  Reversing step 2 and secure the control 

panel back onto the stove pedestal with 
the screws.

9)  The Ground Wire, DC Sparker Ignition 

Wire and Piezo Spark Wire all go 
through the hole located on the pedestal 
back cover. 

10) Put on the plastic split bushing.

11) Attach the Piezo Ignition Wire to the 

back of the DC Sparker box.

14) Connect the DC Sparker Ignition Wire to 

the DC Sparker.

12) The ground wire and DC Sparker 

ignition go through the hole on the heat 
shield.

18) We recommend mounting the DC Sparker 

box onto the pedestal back cover.

19) Check for gas leaks.

20) Check inlet and outlet pressures.

21) Check operation of fl ame control.

22) Check for proper fl ame appearance and glow 

on logs. 

6)  Secure with screw. 

8) Attach one end of the green ground wire 

to the grounding stud on the inside of 
the pedestal. 

13) Apply the plastic bushing to the heat 

shield hole.

15) Attach the green ground wire.

17) Place the heat shield over the DC Sparker.

16) Install the supplied battery into the DC Sparker 

Box by opening the battery compartment.

 NOTE: The battery in the DC Sparker Box will 

need to be replaced annually.