Integra DTR-7.4 ユーザーズマニュアル

22

Using RCA video connection cables, connect the video 
output jack (composite) of the device to the VIDEO 2 
VIDEO IN jack of the DTR-7.4 and connect the video 
input jack of the device to the VIDEO 2 VIDEO OUT 
jack of the DTR-7.4. Or if the device has S video input 
and output jacks, connect them to the VIDEO 2 S 
VIDEO IN and OUT jacks of the DTR-7.4 using S video 
connection cables. Or if the device has component video 
outputs, connect them to one of the banks of 
COMPONENT VIDEO INPUT jacks on the DTR-7.4.
On the initial settings of the DTR-7.4, the VIDEO 2 
input source is set for the COMPONENT VIDEO 
INPUT 2 jacks.
If you connect the device to the COMPONENT VIDEO 
INPUT 1 jacks, this must be changed at Setup Menu 

→ 

Input Setup 

→ Video Setup → Component Video (See 

page 38).
Using RCA audio connection cables, connect the audio out-
put jacks of the device to the VIDEO 2 AUDIO IN jacks of 
the DTR-7.4 and connect the audio input jacks of the device 
to the VIDEO 2 AUDIO OUT jacks of the DTR-7.4. Make 
sure that you properly connect the left channels to the L 
jacks and the right channels to the R jacks.
If the device has a digital output, connect it to either the 
DIGITAL IN COAX jack or DIGITAL IN OPT jack of the 
DTR-7.4, depending on the type of connector on the device.

On the initial settings of the DTR-7.4, the VIDEO 2 
input source is set for digital input at the COAX 3 jack.
If the digital connection is made at a different jack, this 
must be changed at Setup Menu 

→ Input Setup → 

Digital Setup (See page 36).
If the device has a digital input, connect it to the DIGI-
TAL OUT OPT jack of the DTR-7.4 for digital record-
ing of the REC OUT signal from the DTR-7.4.
However, if the same device also has a digital output 
and it has already been connected to the DTR-7.4, you 
cannot connect the digital input of the device to the 
DIGITAL OUT jack of the DTR-7.4 simultaneously.
Note:
The output from the DIGITAL OUT jack of the DTR-7.4 
is only the digital signal input to the DIGITAL IN jack.

Using an RCA video connection cable, connect the 
video output jack (composite) of the device to the 
VIDEO 3 (or 4) VIDEO IN jack of the DTR-7.4. Or if 
the device has an S video output jack, connect it to the 
VIDEO 3 (or 4) S VIDEO IN jack of the DTR-7.4 using 
an S video connection cable. Or if the device has compo-
nent video outputs, connect them to one of the banks of 
COMPONENT VIDEO INPUT jacks on the DTR-7.4.

On the initial settings of the DTR-7.4, the VIDEO 3 
and 4 input sources are set for the COMPONENT 
VIDEO INPUT 2 jacks.
If you connect the device to the COMPONENT VIDEO 
INPUT 1 jacks, this must be changed at Setup Menu 

→ Input 

Setup 

→ Video Setup → Component Video (See page 38).

Using an RCA audio connection cable, connect the 
audio output jack of the device to the VIDEO 3 (or 4) 
AUDIO IN jacks of the DTR-7.4. Make sure that you 
properly connect the left channel to the L jack and the 
right channel to the R jack.