Integra DTR-7.4 ユーザーズマニュアル

24

Using RCA audio connection cables, connect the output 
jacks (PLAY) of the device to the TAPE AUDIO IN jacks 
of the DTR-7.4 and connect the input jacks (REC) of the 
device to the TAPE AUDIO OUT jacks of the DTR-7.4. 
Make sure that you properly connect the left channels to 
the L jacks and the right channels to the R jacks.
If the device has a digital output, connect it to either the 
DIGITAL IN COAX jack or DIGITAL IN OPT jack of the 
DTR-7.4, depending on the type of connector on the device.

On the initial settings of the DTR-7.4, the TAPE input 
source is set for digital input at the OPT 2 jack. 
If the digital connection is made to a different jack, this 
must be changed at Setup Menu 

→ Input Setup → 

Digital Setup (See page 36).
If the device has a digital input, connect it to the 
DIGITAL OUT OPT jack of the DTR-7.4 for digital 
recording of the REC OUT signal from the DTR-7.4.
However, if the same device also has a digital output and 
it has already been connected to the DTR-7.4, you 
cannot connect the digital input of the device to the 
DIGITAL OUT jack of the DTR-7.4 simultaneously.

Note:
The output from the DIGITAL OUT jack of the DTR-7.4 
is only the digital signal input to the DIGITAL IN jack.

The DTR-7.4 is equipped with AC mains outlets for 
connecting the power cords from other devices so that 
their power is supplied through the DTR-7.4. By doing 
this, you can leave the connected device turned on and 
have the Standby/On button on the DTR-7.4 turn on and 
off the device together with the DTR-7.4.

Caution:
Make sure that the total capacity of the components 
connected to the DTR-7.4 does not exceed the capacity 
that is printed on the rear panel (e.g., TOTAL 120W).