Cub Cadet CC 550 ES ユーザーズマニュアル

b.  Remove mulching baffle. See Figure 3-5.

3. 

Follow steps below to attach grass catcher:

a.  Lift rear discharge door.
b.  Place grass catcher on the pivot rod. Let go of 

discharge door so that it rests on the grass catcher. 

See Figure 3-6.

To remove grass catcher, lift rear discharge door on the mower. 

Lift grass catcher up and out, off of the pivot rod. Release rear 

discharge door to allow it to close rear opening of mower.

Never operate mower unless the hooks 

on the grass catcher are firmly seated on the pivot 

rod and the rear discharge door rests firmly against 

top of the grass catcher.

a.   Hold blade control against upper handle.
b.  Pull starter rope out of the engine. Release blade 

control handle.

c.  Slip starter rope into rope guide.
d.  Tighten wing nut.

4. 

Insert post on cable ties into holes provided on the lower 

handle. Pull cable tie tight and trim excess. 

1. 

Follow steps below to assemble the grass catcher (if 

needed). Make certain bag is turned right side out before 

assembling (warning label will be on the outside).

a.  Place bag over frame so that its black plastic side is 

at the bottom.

b.  Slip plastic channel of grass bag over hooks on the 

frame. See Figure 3-4. All the plastic channels except 

center top of bag attach from outside of bag.

c.  Attach center top of bag from inside of bag.

2. 

Before attaching the grass catcher, the mulching baffle 

must be removed. 

a.  Lift rear discharge door.