John Deere ST1332 ユーザーズマニュアル

32

MTF−051059L

Auger Belt Guide

Stack Pulley

Auger Idler Pulley

Auger Drive Belt

Auger Drive Pulley

Figure 40

Traction Drive Belt

Traction Drive Belt

Traction Drive Belt Guide

Traction Drive Pulley

Traction Drive Idler Pulley

If the snow thrower will not move forward, check the traction

drive belt for wear or damage. If the traction drive belt is worn

or damaged, replace the belt as follows.

1. Disconnect the spark plug wire.

2. Remove the auger drive belt. See “How To Remove The

Auger Drive Belt” in the Maintenance section.

3. Loosen the traction drive belt guide(s). Pull the belt

guide(s) away from the traction drive belt.

4. Loosen the nut on the drive idler pulley (see Figure 40).

Move the pulley the maximum distance away from the
traction drive belt and then tighten the nut on the
pulley.

5. Remove the old traction drive belt from the smaller

stack pulley. Then, remove the stack pulley and old
traction drive belt. Replace the traction drive belt with
an original equipment replacement belt available from a
John Deere/Frontier dealer.

6. Install the new traction drive belt onto the traction

drive pulley and onto the engine shaft..

7. Install the stack pulley onto the engine shaft. Then,

mount the traction drive belt onto the smaller stack
pulley. Tighten the stack pulley securely to the engine
shaft.

8. Install  and adjust the auger drive belt. See “How To Re-

move The Auger Drive Belt” in the Maintenance section.

9. Adjust the auger belt guide. See “How To Adjust The

Belt Guide” in the Maintenance section.

10. Install the bottom panel (see Figure 38).

11. Tighten the bolts on each side of the bottom panel.

12. Install the belt cover. Tighten screw (see Figure 36).

13. Check the adjustment of the cables. See “How To Check

And Adjust The Cables” in the Maintenance section.

14. Connect the spark plug wire.