Sharp UX-B800SE ユーザーズマニュアル

If the destinations to which you want to 
broadcast have all been stored in one 
Group Key (see Storing numbers in 
Group Keys which follows), you can 
perform the broadcast operation using 
the following simplified procedure:

Load the document(s).

•

If desired, press 

 to set the 

resolution and/or contrast.

Press the appropriate Group Key 

(

 

or 

). 

•

If the group is a fax group, 
transmission will begin.

•

If the group is an e-mail group, you 

can press 

 to 

select e-mail options (see Steps 4 to 
6 on page 21). When you are ready 

to begin transmission, press 

.

Follow the steps below to store a group 
of destinations in a Group Key.

♦

Rapid Keys 33/G1 and 34/G2 can be 
used as Group Keys. A key cannot be 
simultaneously programmed as both 
a Group Key and a Rapid Key.

♦

Up to 20 fax or e-mail destinations 
can be stored in one Group Key. 

♦

The destinations must be all fax or all 
e-mail. It is not possible to mix fax and 
e-mail destinations.

♦

Only Rapid Key and Speed Dial 
numbers can be stored in a Group 
Key. Full numbers cannot be stored.

Press , 

then  

until 

[ENTRY MODE] 

appears

.

Press , 

then  

until 

[GROUP ENTRY]

 appears.

Press 

 (SET) to store a group. 

(Press 

 (CLEAR) to clear a 

group.)

•

If [GROUP SPACE FULL] appears, 
both keys have already been 

If the memory becomes full during 
scanning, [MEMORY FULL] will 
appear in the display.

♦

Press 

 to send the pages 

which have been stored up to that 
point in memory (the remaining 
pages will automatically feed out). 
After transmission, the memory will 
be cleared and you can send the 
remaining pages. You will also need 
to send the page which was being 
scanned when the memory filled 
up.

♦

 To cancel the entire transmission, 

press .