Sharp UX-B800SE ユーザーズマニュアル
Broadcasting
35
6. Special
Fun
c
tions
6. Special Functions
Broadcasting
You can send the same document to as
many as 20 fax or e-mail destinations in
just one operation.
many as 20 fax or e-mail destinations in
just one operation.
♦
The destinations must be all fax or all
e-mail. It is not possible to mix fax
and e-mail destinations.
e-mail. It is not possible to mix fax
and e-mail destinations.
♦
Only destinations stored in Rapid
Keys and Speed Dial numbers can be
selected. (It is not possible to enter a
full fax number or e-mail address.)
Keys and Speed Dial numbers can be
selected. (It is not possible to enter a
full fax number or e-mail address.)
1
Load the document(s).
•
If desired, press
to set the
resolution and/or contrast.
2
Press .
3
Press
to broadcast to FAX
destinations, or
to broadcast
to E-MAIL destinations.
4
Select a destination using one of
the following methods:
the following methods:
•
Press a Rapid Key.
•
Press
and enter a 2-digit
Speed Dial number.
•
Press
or
until the
desired destination appears in the
display.
display.
•
Press , ,
or
(only for an e-mail
destination).
RESOLUTION/
RECEPTION MODE
B'CAST
SPEED DIAL
5
Press
to enter the
destination.
6
Repeat Steps 4 and 5 for each of
the other desired destinations
(maximum of 20).
the other desired destinations
(maximum of 20).
•
You can press
to scroll
through and check your entered
destinations. To delete a
destinations. To delete a
destination, press
when it
appears.
7
When you have finished selecting
destinations, press
.
•
If you are broadcasting to fax
destinations, transmission will
begin.
destinations, transmission will
begin.
•
If you are broadcasting to e-mail
destinations, you can press
destinations, you can press
to select e-mail
options (see Steps 4 to 6 on page
21). When you are ready to begin
21). When you are ready to begin
transmission, press
.
•
For fax, a Transaction Report is
automatically printed out after
Broadcasting is completed. If any
destinations in the "Note" column of
the report are marked "Busy" or
have a communication error code,
you will need to send the document
to those destinations again.
automatically printed out after
Broadcasting is completed. If any
destinations in the "Note" column of
the report are marked "Busy" or
have a communication error code,
you will need to send the document
to those destinations again.