Omron C200HE ユーザーズマニュアル

If bit 15 of C is ON and more than one address contains the same maximum val-
ue, the position of the lowest of the addresses will be output to D+1.

The number of words within the range (N) is contained in the 3 rightmost digits of
C, which must be BCD between 001 and 999.

When bit 15 of C is OFF, data within the range is treated as normal binary and
when it is ON the data is treated as signed binary.

15 14 13 12 11

00

Data type
1 (ON):

Signed binary

0 (OFF): Normal binary

Number of words
in range (N)

Not used – set to zero.

Output address to D+1?
1 (ON):

Yes.

0 (OFF): No.

If bit 14 of C is ON, values above #8000 are treated as negative numbers, so the
results will differ depending on the specified data type. Be sure that the correct
data type is specified.

Indirectly addressed DM word is non-existent. (Content of 

DM word is

not BCD, or the DM area boundary has been exceeded.)

The number of words specified in C is not BCD (000 to 999).

R

1

 and R

1

+N–1 are not in the same data area.

ON when the maximum value is #0000.

N:

ON when bit 15 of D is set to 1.

: First word in range

IR, SR, AR, DM, HR, TC, LR

C: Control data

IR, SR, AR, DM, HR, LR, #

@MIN(––)

C

R

1

D

D: Destination word

IR, SR, AR, DM, HR, LR

MIN(––)

C

R

1

D

N in C must be BCD between 001 to 999.

R

1

 and R

1

+N–1 must be in the same data area.

When the execution condition is OFF, MIN(––) is not executed. When the execu-
tion condition is ON, MIN(––) searches the range of memory from R

1

 to R

1

+N–1

for the address that contains the minimum value and outputs the minimum value
to the destination word (D).

If bit 14 of C is ON, MIN(––) identifies the address of the word containing the
minimum value in D+1. The address is identified differently for the DM area:

1. For an address in the DM area, the word address is written to D+1. For ex-

ample, if the address containing the minimum value is DM 0114, then #0114
is written in D+1.